Performance Monitors

CAN OBD-II cable for iDash (4 pin). Flat design for enhanced durability and cable routing under the dashboard or around trim pieces. Used to receive ECM data and power from vehicle's diagnostic port.

This remote push button with built in status LED is used to trigger the start and stop of a recording / datalogging session remotely on the Innovate Motorsports PL-1 module.

Banks Bus cable connects iDash located inside the cab to Banks Modules located under the hood. Cable goes through the firewall. (6 pin female - 6 pin female circular twist lock)This Kit also includes the black termination plug used at the end of your...

Banks Bus under hood extension cable. Used to install Banks Modules further apart. Example, install one Derringer Module on left side of engine bay and install a sensor module on right side of engine bay using the B-bus extension cable to connect the two...