Camburg

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood’s 3.5? lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood’s 3.5? lug spacing. They also work with radial mount calipers with the proper machined...

These fender washers are great for mounting fiberglass fenders, aluminum panels, etc. as it spreads the load over a greater surface area. They are CNC machined in-house from 6061-T6 aluminum and are...

Looking to replace the outer steering heim bolts and heim spacers on your Camburg suspension? This kit comes with the necessary bolts and hardware along with the stainless steel top and bottom heim...

Looking to replace the outer steering heim bolts and heim spacers on your Camburg suspension? This kit comes with the necessary bolts and hardware along with the stainless steel top and bottom heim...

Looking to replace the outer steering heim bolts and heim spacers on your Camburg suspension? This kit comes with the necessary bolts and hardware along with the stainless steel top and bottom heim...

We’ve teamed up with the G.O.A.T. of the off-road world Ivan “Ironman” Stewart and MagnaFlow to take your 2024 Toyota Tacoma to the next level with our limited-edition suspension and exhaust system...

Looking for replacement caps for our uniball upper control arms? These are only compatible with our billet or tube uniball upper arms that originally came with caps. You can not retrofit these to...

Looking for replacement caps for our uniball upper control arms? These are only compatible with our billet or tube uniball upper arms that originally came with caps. You can not retrofit these to...

Our Camburg KINETIK sway-bar arms are available in many different lengths, one size doesn't fit all. They are machined in-house from billet 7075-T6 domestic aircraft quality aluminum for optimum...

Our Camburg KINETIK sway-bar arms are available in many different lengths, one size doesn't fit all. They are machined in-house from billet 7075-T6 domestic aircraft quality aluminum for optimum...

Here's the same filler cap kit we use on all our KINETIK race trucks and Camburg 4" rear end housings. The cap is CNC machined from 6061 aluminum, then anodized and laser engraved. It uses an O-ring...

Our KINETIK sway-bar hardware kit includes the delrin pivot bushings that fits into 2? x .120w tubing for mounting, CNC machined anodized aluminum retainer end caps, 4130 chromoly heim tabs for the...

Our heim and spacer kit for our KINETIK sway bars includes four FK JMX-10T 5/8? heims with jam nuts and 4 pairs of heat-treated stainless steel mis-alignment spacers. This allows you to use 1/2"...

Needing to replace our long-travel tie rod extension or wanting a spare? These are machined from heat-treated stainless steel and use the factory inner tie rod and outer tie rod end. They are vehicle...