SPC Performance

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...

Spread the load! "Z" blocks and other axle spacers used by Hendrickson, Freightliner, Kenworth, Mack, Hollis, Sterling, Ford and others create pressure points that will crush or even break the...

This 3 piece set includes: 3.0", 3.5", 4.0" - Often called "dimple dies", flared hole dies are used in sheet-metal fabrications to provide rigidity and strength to flat, unsupported panels. Due to...

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...

Often called "dimple dies", flared hole dies are used in sheet-metal fabrications to provide rigidity and strength to flat, unsupported panels. Due to the resulting high strength -to-weight ratio...

Product appearance and features may vary in the market as design changes, improvements and modifications are implemented.Installation Instructions

Spread the load! "Z" blocks and other axle spacers used by Hendrickson, Freightliner, Kenworth, Mack, Hollis, Sterling, Ford and others create pressure points that will crush or even break the...

Often called "dimple dies", flared hole dies are used in sheet-metal fabrications to provide rigidity and strength to flat, unsupported panels. Due to the resulting high strength -to-weight ratio...

These 3-3/4" steel adjusting sleeves are the perfect fit with our pivot studs and ball joint plates. California Residents WARNINGInstallation Instructions

Product appearance and features may vary in the market as design changes, improvements and modifications are implemented.

This sleeve changes camber and caster on many older model trucks and SUVs with Dana 44 or GMC 10 bolt axles. 4169 spanner socket is required for sleeve removal. Rotate sleeve to fine tune...

Change camber,caster or both at the same time with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve...

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...

Change camber,caster, or both on twin traction beam Dana 44s with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve...